can't access back on http://ratos.local/

i was finalizing my config and went aways for a few day on another project and now i can't access back on to http://ratos.local/
15 Replies
blacksmithforlife
how is your pi connected to your network?
maraissalant
maraissalant14mo ago
wifi
Helge Keck
Helge Keck14mo ago
check if RatOS network still exists
maraissalant
maraissalant14mo ago
yes it is still visible
Helge Keck
Helge Keck14mo ago
then reconnect again and repeat the wifi setup
blacksmithforlife
the ratos hotspot only comes on if it can't connect to the wifi. Those reasons vary so you will have to investigate (wrong SSID? wrong password? too far from router? etc.)
maraissalant
maraissalant14mo ago
ok thx will try so fa i can say that it is not too far from the router my compute still able to auto connect to ratos so no password problem ... i dont know about ssdi
blacksmithforlife
not too far from the router
what is the distance in meters? and are there any walls or floors or anything between the router and the pi?
maraissalant
maraissalant14mo ago
like 3 meters one wall non structural (pl plaster and brick as far as i know no metal stud or anything and it worked before so the signal was good
Helge Keck
Helge Keck14mo ago
use a 2.4GHz network, the RPI hast some issues with 5GHz networks or even better, a ethernet cable
maraissalant
maraissalant14mo ago
it is already on 2.4ghz actualy i have 5ghz and 2.4ghz and i went checking and the pi isnt connected to one or the other
blacksmithforlife
what does systemctl status autohotspot.service say?
maraissalant
maraissalant14mo ago
i am not familiar with this command where do you want me to type it ?
blacksmithforlife
you need to ssh into the machine and write it in the command line
maraissalant
maraissalant14mo ago
i resolved it i hadn't finished the install and put the wifi code on the txt doc on the ssd card on the pi .... --' the fact that it could connect before and after could not got me so focused i forgot that sorry guys