Limited speed
Hello guys,
i'm trying to fix my resonance on my v-minion.
I'm using commands lines from klipper doc :
restart
SET_VELOCITY_LIMIT ACCEL_TO_DECEL=7000
SET_PRESSURE_ADVANCE ADVANCE=0
SET_INPUT_SHAPER SHAPER_FREQ_X=0 SHAPER_FREQ_Y=0
SET_INPUT_SHAPER SHAPER_TYPE=EI
TUNING_TOWER COMMAND=SET_VELOCITY_LIMIT PARAMETER=ACCEL START=1500 STEP_DELTA=500 STEP_HEIGHT=5
i've droped the gcode from prusa slicer with this speed parameters (CF : screenshot)
When i launch the print with the dashboard, speed is limited to 35mm/s when i try to print external perimeters.
Do you have an idea of what is limiting this speed in my slicer (or config ?) ?
Thx 🙂
1 Reply
fascinating-indigo•2y ago
Ok i'll try with a new setting from "cooling". I've put down the "Enable fan is layer print time is below : ..." and "Slow down if layer print time is below:..."