PAM Problem
I installed PAM yesterday and it works. However, my traditional bed mesh runs first and then PAM. I was hoping PAM would become the only bed mesh.
11 Replies
if you are using ratos then you have most likely changed any of the macros
typical-coral•2y ago
Would installing Obico change a macro? I didn't change any intentionally.
typical-coral•2y ago
This is my console since starting the printer.
please share your printer.cfg
typical-coral•2y ago
show your slicer start gcode
typical-coral•2y ago
M190 S0 ; Prevents prusaslicer from prepending m190 to the gcode interfering with the macro
M109 S0 ; Prevents prusaslicer from prepending m109 to the gcode interfering with the macro
;SET_GCODE_VARIABLE MACRO=RatOS VARIABLE=relative_extrusion VALUE=True
START_PRINT EXTRUDER_TEMP=[first_layer_temperature] BED_TEMP=[first_layer_bed_temperature]
MESH_CONFIG X0={first_layer_print_min[0]} Y0={first_layer_print_min[1]} X1={first_layer_print_max[0]} Y1={first_layer_print_max[1]}
START_PRINT EXTRUDER_TEMP=[first_layer_temperature] BED_TEMP=[first_layer_bed_temperature]
do you see the error?
you are calling
START_PRINT two timestypical-coral•2y ago
Yes. Also M190 S0 twice. Thanks Easy fix.
no, the other one is 109
typical-coral•2y ago
That's why you're the king. I wasn't dyslexic yesterday but today's a new day. thanks again.