RRC
ugly-tan
EVA3.0 Shroud FormFutura Apollo X
Hi! I’m trying to print the EVA 3.0 on my Prusa MK3S+ with FormFutura Apollo X.
My print Settings are 265C/100C on a Lack Enclosure.
Fan speed is 30-50% with 50% speed on Bridges.
Speed is at default Prusa.
Any advice?
8 Replies
generous-apricot•3y ago
I would need to see the stl file, but my first guess would be printing orientation. This looks like it was designed to print with the face down. Those look like overhangs that it is struggling to print. Flipping it over would eliminate the overhang.
ugly-tanOP•3y ago
It’s the tank shroud of the eva 3.0 the face is oriented downwards as recommended by EVA’s Websit.
I could just build the Eva without the shroud at first then just print it when the VCore is setup
flat-fuchsia•3y ago
I had this also with apollox.. somehow i needed to burn it before i got some layer adhesion..making terrible overhangs
ugly-tanOP•3y ago
I’ll probably try a different filament.
exotic-emerald•3y ago
Looks like nozzle temp is too high? Recommended nozzle temp on their website says 235-255C
AppoloX has strange reactions. How is your extrusion multiplier ? Go for 0.95 max.
flat-fuchsia•3y ago
Anything lower than 255 gave me horrible Layer adhesion, in a 55°c chamber.. open air (as they advertise) it warped like mad..
265 is probably too hot, try 250-255. For reference I print it at 270 at ratrig speeds