Weird artefacts on perimeters
Are these artefacts caused by pressure advance/smoothing? Pure guess.. unsure where to look to reduce them.
There's both the weird zig-zaggy artefacts at points where it looks like the extrusion is stopping, and then also I have visible edges where other features have been product. These should in theory blend into the sidewall, rather than showing.
2 Replies
xenial-black•2y ago
This is not caused by PA. This is an overlapping issue. Most slicers have an overlapping value of 25 %. Try to reduce it to about 15 % and check if it is getting better. Also a solution could be to change sequence of walls.
wise-white•2y ago
Thanks! I'll take a look and try to test it 🙂