Z Axis wont stop at the top of lead screw when homing.

I am doing my initial setup right now and when I home the z-axis everything seems to be working fine, probe triggers and tool head doesnt crash into bed but then it wont stop at the top of the lead screw.
i added the printer.cfg. Would appreciate your guys help very much.

printer_2.cfg14.71KB

miklschmidt•5/11/23, 7:14 AM

but then it wont stop at the top of the lead screw

Can you clarify the actual issue?

urgent-maroonOP•5/11/23, 12:18 PM

I tried homing all the axis and when doing the z one it went down to the bed no problem and the Probe triggered then it went up and If I hadn’t pressed emergency stop it would have just kept going and detach from the screw

blacksmithforlife•5/11/23, 1:10 PM

did you use SET_CENTER_KINEMATIC_POSITION SET_CENTER_KINEMATIC_POSITION before homing?

urgent-maroonOP•5/11/23, 3:06 PM

i didnt now everything works perfectly thank you

FFreddi i didnt now everything works perfectly thank you

blacksmithforlife•5/11/23, 6:27 PM

SET_CENTER_KINEMATIC_POSITIONSET_CENTER_KINEMATIC_POSITION is just for debugging - it will not fix your issue

Z Axis wont stop at the top of lead screw when homing.

Similar Threads

Similar Threads

Similar Threads