Can someone pls check my printer.cfg
is there someone that could check my printer.cfg ? i changed some stuff but i cant remember what and now my printer is having some issues
13 Replies
can you be more specific as the the issues you are having?
so one issue is that my prints don't stick anymore it looks like the printer ignores the ,mesh and just prints in mid air. another one is a clogging issue but that has nothing to do with the config i think. another one is weird looking corners they look underextruded. and all that happend after i changed some stuff but i cant remember what.
did you do a probe calibrate? Maybe your z-offset is incorrect
yes i did with a piece of paper and it felt pretty good, but when i started to prinrt it didnt stick
did you home before doing the probe calibrate? Did you fine adjust with a live print after doing the probe calibrate?
yes i homed first .and i tried to live adjust but nothing really happened i pressed -0.5 multiple times but nothing seemed to change with the print
Sounds like your z offset need attention. what bed temp? clogging is not enough hot end cooling although silk, metalic, carbon filled filaments are known to easily clog.
60C bed temp
all that clogging started after i used 85a tpu not quite sure what happened there. so far i only tried petg , pla and tpu. i bought some esun cleaning filament maybe that will help
@blacksmithforlife 🇺🇸 so I still have the extrusion issue. the print starts and then it just stops extruding and it looks like this. I am not able to feed filament by hand I have to do it via the command because I can't push it through. is it possible that the diameter of my pla changed?
Sounds like either your hotend has a problem or your filament has bad tolerance
I'll try some stuff out tomorrow
a fixable problem ?
@blacksmithforlife 🇺🇸 maybe i found the problem with 10mms extrusion feedrate it says 24.1 mm³/s, in my slicer i had volumetric speed at 30mm³/s maybe that was the problem or i cleaned everything that cloged it/ filament had bad tolerances
I guess I fixed it
