Topics

Rat Rig Community [Unofficial]•13mo ago

what is this?

No description

No description

11 Replies

blacksmithforlife•13mo ago

I can't help myself - looks like a cube kekw

kekw

Plynix•13mo ago

i mean the weird suface

blacksmithforlife•13mo ago

sorta looks like salmon skin effect or ringing

Plynix•13mo ago

Hmm

No description

Plynix•13mo ago

Must be a belt problem

blacksmithforlife•13mo ago

You probably have them too tight

Maba_Kalox•12mo ago

so, did you solve the problem? I have exact same thing, and I dont understend how loose should I make them to solve it...

Plynix•12mo ago

lower belt tension 2 full turns to the left and fixed it @maba_kalox

Maba_Kalox•12mo ago

hmm, lets try...

Maba_Kalox•12mo ago

hm. if I do even one turn my shaper graph becomes garbage and belts are very loose...

No description

No description

Maba_Kalox•12mo ago

but I guess it would be better to open separate thread for my problem 8)

Rat Rig Community [Unofficial]Join

12KMembers

View on Discord

Want results from more Discord servers?

Add your server

More Posts

How should do to adjust the firmware.config to enable CONFIG_INITIAL_PINS="xx_xx" permanently.I have a V-Core 3.1 500 with BTT Manta M8P V1.1 and CB1 + BTT Relay V1.2 conectet to Pin PC3. In ord Arctic 12V mit BTT Board verbindenHabe diesen Fan https://support.arctic.de/s4028-15k und würde ihn gerne an das Board verbinden wie m V-Minion: X Graph good, Y Graph badI cannot for the life of me get the Y axis on this thing to tune well. The printer is sitting on a h SKR 2 dead?My SKR 2 seems to be dead. I get an error that a temperature is outside the allowed range. I first Unable to read tmc uart 'extruder' register IFCNTa. I had a FLY-SHT36, working, but was missing a few connectors, so removed it b. ran the toolhead a Goliath Hotend may extrusionI have a Goliath Hotend on my V Minion and I get this error message. Where can I change it?RatOS unstable since Crowsnest updateLeft untouched for a few hours, camera is often unavailable and crowsnest needs to be restarted. In Adaptiv Bed MeshHallo test gerade das neue mesh, habe bis jetzt pam benutzt von Helge, hat super funktioniert. Solt VC 3.1 500 valleySince a while I can't seem to get a proper bedmesh (nor proper first layers) on my vc 500. It was wo No trigger on z after full movementI am working on setting up a v-minion for the first time and have run into a problem while testing h