![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Not sure what is causing this.....
Hi everyone. Swapped my slicer to Orca Slicer after some issues with Super Slicer in regards to infill seemingly badly under-extruded.
Was running some test prints after calibrations etc and almost done, but my Benchy seems a bit strange on one side with some strange artefacts on it. Subsequent prints replicate it as well, so there is something that I have yet to optimise on it.
Any suggestions would be really appreciated
Was running some test prints after calibrations etc and almost done, but my Benchy seems a bit strange on one side with some strange artefacts on it. Subsequent prints replicate it as well, so there is something that I have yet to optimise on it.
Any suggestions would be really appreciated
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}