RRC
Rat Rig Community [Unofficial]intermediate-olive
Ran update, MCU no longer reachable
Assume it's due to the thing in #announcements though, i'm on a Octo board, do i missunderstand, but should that not be affected?
intermediate-olive•345d ago
....
nevermind
you know when you ask for help, is the second it suddenly works
i swear, it's not been connecting after reboots after reboots, checking for updates, powering off and on
but now, as i click restart, it instantly connects properly
intermediate-olive•345d ago
well something is still broken
i'm unable to get a print going, it errors out
intermediate-olive•345d ago
and now it works
starting to suspect a loose wire or something, with it being so intermittent
Quinny•344d ago
i'd say wiring, try another usb cable
Want results from more Discord servers?
More PostsCrowsnest - Webcams wont show work.Hello, I have tryed for hours now and i cant get my cameras to work. I have updated to V4.
My log:Dramatic later shift every layerI have a Vcore 500mm, and I'm experiencing these layer shifts at 15k accel. The grub screws are tighFresh RatOS install Crowsnest brokenJust a heads up, I had to do a manual "git pull" in ssh to update crowsnest when doing a fresh instPoor Bed adhesionHaving trouble with bed adhesion (again). Can't get ASA to stick to it, I have to wash it with soapyMesh levelling stopping about halfway through G29My BLTouch seems to be working, homes fine, but it can't complete a G29 mesh. It stops with the warnIssues w. extruder stepper (LDO-36STH20-1004AHG from lgx lite) since upgrade from RO2.0.0 to v2.0.1my stepper doesn´t work since the upgrade and reflashing the sd card. The stepper doesn´t react, no Strange Bed Level Test ResultHow can I fix this?belt shiftingOk..I have a odd issue that doesn't make any sense. I did a print almost 2 weeks ago and shut the prdouble peaks on YHi, did someone have such graph? Did you managed to fix it? Any ideas why is it so?Part Cooling Fan dauerhaft aktivSeit neuestem ist bei meinem Minion der Lüfter für die Bauteil Kühlung dauerhaft aktiv. Ich konnte lCan't equalize belt tensionI have such graph currently, if I try to tighten lower belt, my gantry moves out of square(when I moBed tilted after G34Hello everybody,
Here is another mesh/homing problem. Maybe a really simple thing, but I don't get Extruder Heater not Heating at Expected RateI've gotten this error message 3 times in a row and I've noticed the temperature on the extruder seefan.cfg benötigtWie muss denn eine Fan.cfg aussehen, wenn ich bei Überschreiten einer vorgegeben Temperatur vom Mainprinting round tubesHaving trouble printing round stuff this is PETG and currently running 240c .15mm layer height. 2mm Extruder spinnt....Rest kommt. Strom braucht das Laptop