![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Klippy Host Software Can't Connect
I just set up my ratrig vcore 3 with rasberry pi 4 and BTT octopus V1.1 board. I have been trying to get it working, but after following the setup guide, I setup the firmware, flashed it, but after editing the printer.cfg step, I get the message "Printer is not ready, The Klipper host software is attempting to connect. Please retry". I have restarted the printer and firmware but it doesnt change. ANy advice? Im pretty new to klipper so its been challenging. Thanks!
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}