Adaptive meshing, printing outside of "meshed" area
I'm having a weird issue, after messing around with ROME and then removing it , then enabling the adaptive bed meshing and priming; having something strange going one.
It starts with probing of the purge area, bed mesh is done according to the size of the part located in the bed center, then it purges almost in the middle and starts printing in the far left corner...........with the carriage gantry brutally smacking the back of the Y axis like the whole coordinate system is shifted.
Not at home, though ti had uploaded the klippy and printer.fg files but seems not..... will put them here when i get back.
Was thinking about maybe there is a relative vs absolute coordinates conflict somewhere.......
Help appreciated .
2 Replies
You're having problems with skipped steps / loose pulleys / etc. Not adaptive meshing.
Check your mechanics.
well, it happened after moving it by car to a friend's place and you ere right, the gantry was not square to the front frame anymore......one side of the gantry was touching before the other.
removed the belts, loosened all the screws and realigned it, now it does what it's asked for
Tnx for the tip !!