![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Volcano Hotend Issue
Hi,
I got an issue with my Volcano. It cannot run at low speed.
Recently I print PETG.
230C, 90% fan. Max flow at 13mm3/s on 0.4 Nozzle (normal, not CHT)
But it only get well when speed is >80mm/s. Everything lower than that? Under Extrude
I got an issue with my Volcano. It cannot run at low speed.
Recently I print PETG.
230C, 90% fan. Max flow at 13mm3/s on 0.4 Nozzle (normal, not CHT)
But it only get well when speed is >80mm/s. Everything lower than that? Under Extrude
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}