![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Overextrusion at my seams. Motion seems to pause.
I'm working on printing nylon. So I have my speeds dialed down to 60mm/s for the most part. However, it seems like the motion pauses at layer change or retraction and ends up causing a bit of overextrusion. Where is the parameter in Prusaslicer that drives this speed? I've been digging and can't seem to puzzle out which knob needs to turn. 
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}