RRC
Rat Rig Community [Unofficial]•11mo ago
sensitive-blue

extruder Problem

When i want to extrude some filament i for this error TMC 'extruder' reports error: DRV_STATUS: 001600e0 s2vsb=1(ShortToSupply_B!) ola=1(OpenLoad_A!) olb=1(OpenLoad_B!) cs_actual=22 I use an ebb42 1.2 toolboard . This is the Pin from the extruder to the toolboard
No description
3 Replies
blacksmithforlife
blacksmithforlife•11mo ago
some sort of wiring issue since it is saying it has a short in the error message
sensitive-blue
sensitive-blue•11mo ago
Like the cables in the wrong Order? Ok i fixed it .
sensitive-blue
sensitive-blue•11mo ago
No description
Want results from more Discord servers?
Add your server
More Posts
uart pin must be specified[Errno 13] Permission denied: 'eslint-patch'Trying to fix this...soft and hard recovery do not work. I get the above error in title. [Errno Toolboardsarent some toolboards scuffed from btt,or is the supporeted list the known safely toolboardsproblem with initial firmware install.Hello! when I do the initial firmware install, it will say that my octopus is detected but not respoAny ideas on what to fix?Any guidance would be appreciated. It’s tricky to understand what the areas of the height map are onGap between seemHi Team, I'm using super slicer and I am getting a gap between the seem. Does anyone know what I neeVerify heater/suspected thermistor issueI have been getting intermittent verify heater extruder errors where multiple 5+hr prints can go norParallellogram printsI posted a while ago about suspecting the printer wasnt all square, and I just can seem to figure ouBoards are no longer listed in the PiI have the problem that after the system update my octopus and my 2 ebb42 are no longer listed underMoonraker can't connect to Klipper after updatingAfter I update the printer it just dont connect, Ive read about the uds paths and tried several work