EBB36 adxl axis swapping
I'm setting up a new toolboard and it is mounted on the back side of the tool head. Looking at the initial belt tension I think the axes need to be swapped. I added 'axes_map: x, z, y' to config, but it doesn't seem to change. Am I missing something?
2 Replies
flat-fuchsia•2y ago
Orientation does not matter
magic-amberOP•2y ago
Problem solved: As I was tightening the belt, the end slipped out of the belt clamp. turns out the block on the back of the carriage had cracked and was no longer grabbing.