I'll add this to the next maintentace firmware release
I'll add this to the next maintentace firmware release
L
whaaaat didn't know that menu exists, is it module specific?
MSweet, I'll let you know if it wakes up those buttons
NIt is.. I have the built-in shake effects disabled on the Spitfire, using TelemFFB in stead. You can see it in the joystick profile if you change from defaults.
NI never knew it existed either because I always have "foldable view" enabled which removes all the options buttons at the bottom of the screen
N
TTHas anyone with a viripl mongoose grip on the rhino experienced this? Just lightly tapping the brake lever makes the value spike a bunch?
TMy guess is that this is a hardware issue in the grip
Nare you using the virpil offset extension by chance?
TI am
Nhave you tried with the grip directly attached to the rhino?
TI have not, but that is a good idea
NI ask because myself and several others have had flaky wiring in the virpil extension.. I took mine apart and replaced the wire, but it was kind of a PITA honestly..
TNope, same effect
Nahh.. well, that good its not the extension but bad its either the grip or the rhino
TYeah
TI did yep
WOn a second though yeah, it looks like a hardware issue in grip
TI guess I'll have to send an email to vipril then 
WYou can manually calibrate it out though
Twith a deadzone?
WIncrease the min value so the glitchy part is below zero
TI suppose so yeah, though it seems to be glitchy across half the range
TWell, only slightly glitchy above 25% range, so this should be usable until I get around to complaining 
TThanks for the help
KHi, think I might have broken my base..
I hooked it up, when powered on it wanted to center , and more so when tuning the knob. tried to calibrate in the calibrator app, but it will not "do" anything i msfs, the force feedback worked for a bit , but then
I hooked it up, when powered on it wanted to center , and more so when tuning the knob. tried to calibrate in the calibrator app, but it will not "do" anything i msfs, the force feedback worked for a bit , but then
Kit just stopped doing anything, it is limp.
KI cloned the git repo, it is receiving telemetry from msfs just fine, so that part is working
KI'm a sad puppy
ACan you post screenshots of your configurator settings?
Kmoment
AFrom a debug perspective — we should focus on the device first to make sure it’s working properly, then secondary focus on the telem app and msfs, since very different situations
AAnd just for a general gut check — the emergency button isn’t pressed in right? The red one. You have to rotate to pop it in the up position
K
Kyes, you are probably right
Kit is not pressed, correct
AWhen you move the stick, do you see anything on the left side move?
Kyes
AOk cool
ASo all those sliders — should be at 100%, except leave periodic effects at 50%, and maybe set Friction to 7%
WSettings look like they were reset to board defaults
Kaha, yes, something sure happened now
WYou can import rhino stock settings from the
configs directory in the configurator appA(Will let walmis take it from here cause he the expert)
W
KI did, it went limp again..
Wpot knob is perhaps at 0 ?
Knot compleatly limp. i wants to come backwards now
WCan you show the effect/settings and debug tabs?