RRC
Rat Rig Community [Unofficial]•9mo ago
captain.fpv

Y axis vibration. is it NORMAL?

So i am trying to reduce the y axis vibration and achive more accelerations. I have taken apart everrything and relubed the rails but they still doesnt seem right . I have attached a video of the same. does the sound seem weird?
10 Replies
complex-teal
complex-teal•9mo ago
sounds normal...? atleast exactly the same as mine sounded last i had it apart, and i think mine is in good condition
probable-pink
probable-pink•9mo ago
Mine sound the same, I think it is normal
captain.fpv
captain.fpv•9mo ago
but thats a lot of vibrations at the speed im moving how do we get rid of that?
complex-teal
complex-teal•9mo ago
it depends, you have lots of small balls in the bearing blocks, they'll make some noise, that's just what they do since i can't feel the vibration through my screen, i can't really give any advice apart form looking for metal shavings and pieces
captain.fpv
captain.fpv•9mo ago
what lubricant are you guys using for the rails?
complex-teal
complex-teal•9mo ago
5-56 spray don't know if it's a good or bad idea yet
probable-pink
probable-pink•9mo ago
probable-pink
probable-pink•9mo ago
What vibration you talking about? It moves smooth
captain.fpv
captain.fpv•9mo ago
No description
captain.fpv
captain.fpv•9mo ago
reassembled
Want results from more Discord servers?
Add your server
More Posts
Calibration after upgradeHello guys, I did the 3.1 upgrade and installed a rapido 2 on my v core 500. However nothing comesConsistent 2mm Z banding. 3.1I'm struggling to solve this Z banding. This test was with PLA @ .3mm height. Happens with or withou4028 does not turn off at 0% even with enable_pinPart cooling fan 4028 Sanyo keeps spinning at low rpm at 0% even after wiring gnd to HE3 and settingMesh ProblemIch habe das Problem, dass ich mein mesh nicht unter 1,4 bekomme egal wie ich den rahmen ausrichteSlincer or print problemHi, i try to print this stl and i try to change v, acc and retraction, temp ecc Material abs+ sunlu V-core3-Octopus 1.1 -Pi 3a+ Ratos 2.02 : stops printing randomly #solvedHi all, This printer has been running about 2000 h. It started to stop at various height (tried difFiberlogy Nylon PA12+CF auf meinem V-Core 3-300 mit GehäuseHallo zusammen, Ich versuche meinen Drucker auf das Fiberlogy Nylon PA12+CF Filament einzustellen. Aripping/tearing of first few layers in one local spot on large print.The first few layers ripped and teared in one local spot on a large print. What might have been the Issue with overhang first layer and support bridgingI'm having some issues with overhangs as seen in the xyz cube, the first layer of the overhang for tRapido hotend not going below 179 degreesHi, have built a ratrig V core 3.1 with a rapido uhf and an octopus 1.1. As soon as klipper starts t