W1-AT PCB caps lock LED pads lifted
Hello, the caps lock LED pads on my W1-AT PCB lifted. Where should i jump the LED ends to?
5 Replies
its not the pad, it looks like u killed a diode
i desoldered the SMD LED so i could solder a through-hole LED to the pads
like Glare posted, the cathode of the LED (D93) would connect to R3. then it looks like the anode of D93 would connect to the anode of D44, but the trace goes under the diode so i'm not 100% on that
perf, just wanna make sure it goes to the anode of D44
or if it's a diff one, would like to know