![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
issue: hotend pid tune with fan
I have a vcore 3.1 (mosquito kit)with the following HW:
Phaetus dragon high flow(changed)
60w heater
Pt1000 thermistor
Ebb36 toolhead
Delta 12v 4028 fan
This is a new build.
The issue I'm having: when I do a pid tune without fan at 260°C it works, when I do a pid tune with fan at 40% the pid tune doesn't finish. But errors out with: heater not heating at expected rate.
I had this issue from the start.
I redid all wiring (found the 24v to the ebb36 not 100% seated).
But still I'm facing the issue. Any ideas?
Phaetus dragon high flow(changed)
60w heater
Pt1000 thermistor
Ebb36 toolhead
Delta 12v 4028 fan
This is a new build.
The issue I'm having: when I do a pid tune without fan at 260°C it works, when I do a pid tune with fan at 40% the pid tune doesn't finish. But errors out with: heater not heating at expected rate.
I had this issue from the start.
I redid all wiring (found the 24v to the ebb36 not 100% seated).
But still I'm facing the issue. Any ideas?
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}