Option 'control_pin' in section 'bltouch' must be specified while selecting pinda as probe
Can someone please help me figure out where I go wrong in my config? Switched from bltouch to pinda while doing the tollhead upgrade. And Pinda is connected to the tollboard. Thank you
23 Replies
You need to comment out the [bltouch] sections in your printer.cfg and remove it from the klipper config section at the very bottom (the one that tells you not to touch it).
hmm
Remove these 3 lines
And you should be good to go
line 526 and 527
you a genius again guys
is it normal that I have both endstop Z and probe?
yes
thank you
I have one more question if I may
the orbiter wires colors are different from the wiring diagram
how can I guide myself to connect it properly?
this is the diagram
Did it come with a jst-xh connector on it?
while I have red, green, yellow and blue
yep
then try using it as is first
worse case, it won't turn
then you need to swap pins
well, I dont't want to fry it
you won't
so just go crazy and connect it as is?
yes
ayay
did it work?
like a charm
š
thank you lots
appreciated
Sat last night wondering about the same question on the wiring... Also did not like the "Just plug and pray" option... but here it all is.... should have just come to Discord where good knowledge is shared....š
Thank you this old reply and sample saved me.