![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Prints "grow up" when ends to print supports
Hi guys, I have a problem printing a model on my vcore 500.
The model was printed diagonally because it had an approximate size of 600x45x413 mm. As you can see in the photos, it needs supports, and when it finally finishes printing the central hole, the model begins to grow towards the corners, as if it were being stretched. The thickness remains the same, but goes from approximately 600 to 602mm. It is not a loss of steps, since it goes towards the two opposite corners.
I sliced it twice, but nothing changes. Any idea what's going on?
Thanks in advance.
P.S. Vcore 500, rapido UHF 0.6, PS default profile slightly modified to reduce some speeds.
The model was printed diagonally because it had an approximate size of 600x45x413 mm. As you can see in the photos, it needs supports, and when it finally finishes printing the central hole, the model begins to grow towards the corners, as if it were being stretched. The thickness remains the same, but goes from approximately 600 to 602mm. It is not a loss of steps, since it goes towards the two opposite corners.
I sliced it twice, but nothing changes. Any idea what's going on?
Thanks in advance.
P.S. Vcore 500, rapido UHF 0.6, PS default profile slightly modified to reduce some speeds.
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}