ADXL345 shows up as faulty
My
[include RatOS/printers/v-minion/steppers.cfg]
is uncommented and I put this in the printer.cfg file: [mcu rpi]
serial: /tmp/klipper_host_mcu
[adxl345 rpi]
cs_pin: rpi:None
[resonance_tester]
accel_chip: adxl345 rpi
probe_points:
100, 100, 20
I have already tried running the command like so :ACCELEROMETER_QUERY CHIP=rpi
, but the same error occurs.
I have also checked the wiring, its all connected properly.
The seller of the ADXL345 seems to have tons of reviews, none of which are saying the chip is faulty. Thanks for any and all help!1 Reply
Upload your printer.cfg. also, you may have wired it correctly but the adxl are very sensitive to electrical noise. What wiring did you use for the adxl?