![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
RRC[nursing-lime
4P Part cooling Fan, Config problems
Hi guys,
I have a problem with setting up a FAN in the Printer.cfg of my Minion.
The FAN stops from 0-10% again. From 10-100% it runs, but with fluctuation in speed. You can also hear how it runs faster and slower.
The tacho is only recognised up to about 17000, the FAN runs 30000-35000 at 100%. Is this normal?
Board: SKRat
Port: Four-Wire-FAN1 (12V Jumper)
FAN: 4028 WAKEFIELD DS0402812W2B-BT0
I would be very grateful for any help.
I have a problem with setting up a FAN in the Printer.cfg of my Minion.
The FAN stops from 0-10% again. From 10-100% it runs, but with fluctuation in speed. You can also hear how it runs faster and slower.
The tacho is only recognised up to about 17000, the FAN runs 30000-35000 at 100%. Is this normal?
Board: SKRat
Port: Four-Wire-FAN1 (12V Jumper)
FAN: 4028 WAKEFIELD DS0402812W2B-BT0
I would be very grateful for any help.
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}