![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
RRC[then-purple
Support walls with gaps
Hi All,
RatRig VCore 3.1 500
Printing with ABS
Orbiter 2.0
Rapido UHF
got pretty long print ahead of me (~120h). Tried it once and had failure due to of active enclosure heating. Overall everything is OK but the side walls of supports looks odd to me. Tried to tweek it a bit with slicer (PrusaSlicer) settings, but don't know in which direction should I go.
E-steps calibrated (120mm in Mainsail == 120mm IRL)
Printed temperature tower and choose appropriate temp for this filament.
Thanks in advance for your help!
RatRig VCore 3.1 500
Printing with ABS
Orbiter 2.0
Rapido UHF
got pretty long print ahead of me (~120h). Tried it once and had failure due to of active enclosure heating. Overall everything is OK but the side walls of supports looks odd to me. Tried to tweek it a bit with slicer (PrusaSlicer) settings, but don't know in which direction should I go.
E-steps calibrated (120mm in Mainsail == 120mm IRL)
Printed temperature tower and choose appropriate temp for this filament.
Thanks in advance for your help!
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}