![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
RRC[faint-white
Taco, pancake, saddle... mesh
alright. I performed the enclosure 2.0 upgrade and now I've got a mesh that flexes from a Taco to relatively flat, and then to a Saddle as it heats. attached are three meshes, cold. heated 45min-1hr, and heated for 2hrs then loosened the x linear rail, and extrusion attachments and re tightened.
I'm still just barely under .5mm and it makes large full bed prints unlikely to succeed.
my frame is pretty darn square, and the only other advice I saw was loosen the linear rail and re-tighten. I've looked under the built surface and there is nothing pushing it up in front where I have the high spot.
would appreciate any suggestions as long as they are not "watch that same video that's been linked over and over again."
I'm still just barely under .5mm and it makes large full bed prints unlikely to succeed.
my frame is pretty darn square, and the only other advice I saw was loosen the linear rail and re-tighten. I've looked under the built surface and there is nothing pushing it up in front where I have the high spot.
would appreciate any suggestions as long as they are not "watch that same video that's been linked over and over again."
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}