![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Shaper calibration: Fans on or off?
Hello.
When running shaper calibration, should the fans be on "as normal" (Ex: Print fan @ 100% and heatbreak fan on) or should they be completely off?
I found a reddit post from years ago about it, and there was a response that recommended them being on, but I haven't seen it discussed here or on any official klipper posts
When running shaper calibration, should the fans be on "as normal" (Ex: Print fan @ 100% and heatbreak fan on) or should they be completely off?
I found a reddit post from years ago about it, and there was a response that recommended them being on, but I haven't seen it discussed here or on any official klipper posts
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}