![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Internal Error on "G4"
Looking for some assistance on below. I have an Orbiter 2.0 (on a RR3.1-300) with the orbiter filament runout sensor. I have installed, and are running the macro's that go allong with that. It has been working flawlessly for months but now, Since a couple of weeks I get an error.
When I run out of filament, the toolhead is parked in the back and any remaining filament is pushed out the back/up as normal and than it awaits the user (me) to add filament. When the filament is grabbed by the Orbiter, I get an error on screen stating: "Internal Error on command: "G4" "
I then need to do a firmware restart but lost the print. The part of the klippy.log (attached) also shows me another error: FILAMENT_LOAD
Not sure what is going on. I did not alter any of the Macro's. Any help would be appreciated.
When I run out of filament, the toolhead is parked in the back and any remaining filament is pushed out the back/up as normal and than it awaits the user (me) to add filament. When the filament is grabbed by the Orbiter, I get an error on screen stating: "Internal Error on command: "G4" "
I then need to do a firmware restart but lost the print. The part of the klippy.log (attached) also shows me another error: FILAMENT_LOAD
Not sure what is going on. I did not alter any of the Macro's. Any help would be appreciated.
message.txt16.44KB
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}