RRC
Rat Rig Community [Unofficial]•5mo ago
jamalt2946

ADC out of range

Hi I have this problem which I don’t understand I checked every thing.. and all ok
No description
3 Replies
JaminCollins
JaminCollins•5mo ago
ADC out of range is most likely (if not completely) due to loss of communication with the thermistor. Whether that's a faulty wire, connection, or failing thermistor is the question.
Prav
Prav•5mo ago
you get the same error if the temperature is out of configured range. which can happen if the config is incorrect. eg. pullup_resistor is set wrong, or printer is in a cold space with min temperature set too high
MichaelKnight
MichaelKnight•5mo ago
i got this error once when i didn't plug in the 2 temp sensors while i was troubleshooting another issue. plugging them back in fixed it. you may want to start with the plugs. what board?
Want results from more Discord servers?
Add your server
More Posts
Unable to read tmc uart 'stepper_z' register IFCNTHello, i have the vcore 3.0 500 steppers from ratrig tmc 2209 btt skr pro 1.2 raspberry pi 3b revoRetries aborting: Probed points range is increasing.I am unable to do the Z-tilt homing. I get > Retries aborting: Probed points range is increasing. AfUpgrade control board from Octopus Pro H723 with TMC2209 drivers to my new Octopus Max EZ with EZ516I would like a bit of help I am looking to upgrade my current control board Octopus Pro H723 with TMSD Busy in Klipper TerminalGuten Tag, hatte jemand schon mal die meldung SD Busy? Ist das ein Speicherkarten fehler. Im Pi stecOrbiter Sensor / Ratos MCU error after loading filament and ResumeI have a orbiter 2 with filament sensor, configured as per attached printer.cfg on a EBB36. This useconfigure other ip's than 192.168.50.1?is this possible an how can i approach it? since ill be running multiple ratrig printers and i would"Filament Unloaded" After starting print. New BTT Smart Sensor V2 - Filament RunoutI seem to have the filament runout sensor installed and working correctly. However everytime i startBond tech LGX Lite clickinghaving issues with my bondetch lgx lite clicking and hotend clogging since upgrading to EVA3, tried Lgx lite and rapido 2 constantly clogging.After a print goes for a couple of hours sometimes 10 hours sometimes longer. there will be an clog Move out of range when performing Bed Mesh.Running the new beacon rev H probe. tried adding position_min: -5.0 to [stepper_z] but no help. homi