![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Wavy patterns in vertical print surface V-Minion. Orcaslicer default profile PLA.
I'm on the most recent Orcaslicer using the default V-minion profile, .6mm nozzle. This is at about 25% speed.
This picture is the vertical on the x-axis front of the printer. The backside is a little bit cleaner. Sides are also cleaner.
Belts seem good. After I saw this pop up I tuned input shaping. I think the extruder rotation distance is good but I might check that again. Bed leveling is good. I've tried different PLA filament rolls, same result.
Any idea what's out of whack by looking at the picture?
This picture is the vertical on the x-axis front of the printer. The backside is a little bit cleaner. Sides are also cleaner.
Belts seem good. After I saw this pop up I tuned input shaping. I think the extruder rotation distance is good but I might check that again. Bed leveling is good. I've tried different PLA filament rolls, same result.
Any idea what's out of whack by looking at the picture?
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}