RRC
Rat Rig Community [Unofficial]•4mo ago
Achi447

Weird Pattern on flat Walls

So I had this issue before and I'm not sure how I fixed it the last time. It's a weird Pattern on the Walls. I switched from CF-PETG to PLA and this Pattern appeared in the first print. Angled surfaces look fine, but flat ones have this pattern. I'm using a Vcore 3.1 400
No description
No description
4 Replies
Achi447
Achi447•4mo ago
(Print looks bad overall because I printed to fast with not enough cooling)
Achi447
Achi447•4mo ago
No description
Achi447
Achi447•4mo ago
maybe it could be binding ?
Achi447
Achi447•4mo ago
No description
No description
Want results from more Discord servers?
Add your server
More Posts
nevermore filter controlI just installed a nevermore filter in my enclosure and would like to start it and stop it with the Belt issuesSo I have two issues going on with my upper belt that I am going to replace. The first is I am gettiFirst Layer / Mesh ProblemAny ideas on why I am seeing this and what I can do to correct it? Essentially One part of my firstPre-heating extruder...Hi, For my application I'm using a costum extruder without a thermistor. When I start my print it Bad filament?Hi, is my Yellow ABS bad ( wet? ) ? in blue ABS print coms out flawless eventhough blue is 7 years oshould bed leveling be this tilted?I've just set up my vcore 3.1 400mm and run the bed mesh, and I get this very titled bed mesh. (I haBad First Layer Outside of Probed AreaBasically always getting bad first layer on the right side of the plate where the probe can't reach.Monoblock Carbon Fiber Hemera XS 3.1 500HI all, I am running some initial testing of a V-Core 3.1 500 with Hemera XS with a very stiff, tigHow do I manually flash my Octupus after a failed flash?Currently getting error: ```MCU Protocol error This is frequently caused by running an older versioHot end heater pin migration problems.Hi, i have a problem whit my hot end heater. It is no longer heating, i managed to measure the conti