Overhang improvement? V-core 3.1
(Dont mind the change of color, I was testing the runout sensor.
The included photos are my slicer settings, the model is the "CURVE OVERHANG TEST" free from Cults3d. Im printing with a .4mm nozzle, .2 layer height, .4 layer width.
Is this as good as it gets? Any thoughts on how to further improve the result?
The included photos are my slicer settings, the model is the "CURVE OVERHANG TEST" free from Cults3d. Im printing with a .4mm nozzle, .2 layer height, .4 layer width.
Is this as good as it gets? Any thoughts on how to further improve the result?
1 Reply
This started when I printed this big articulated dragon. The joints were not as pretty as I wanted them to be, I think I've made progress but I wonder if it can be better?