RRC
Rat Rig Community [Unofficial]•3mo ago
chrisforce

Any ideas ?

The Belt is new the noise also :/ the upper belt in the left conner make noises and the belt looks after some prints a little but damadge :/
No description
1 Reply
K1ear
K1ear•3mo ago
i had a very similar issue i flipped the belt upside down it stopped the belt from moving up and rubbing against the bearings
Want results from more Discord servers?
Add your server
More Posts
My prints are interrupted.Hello. My printing has been interrupted for the last few days. The clipper connection is also workinconsistent Z marksI was running some ghosting prints which turned out OK other than the Consistant Z marks. This is thAutofocus won't turn offI can't get my autofocus to turn off. I have a 3do camera from kbb. I have attached my crowsnest cSeems I have over compensated. How close is good for a 500?I have an enclosed model. Given my panels, it seems I dont have too much room, thoughts?[pause_resume][pause_resume] [gcode_macro M600] gcode: {% set X = params.X|default(50)|float %} {% set Y Config files not displayed after updateAfter a long overdue update my config files are no longer displayed in Mainsail. I was hoping thisPLEASE HELP! I cant seem to flash RatOS onto my boardI cant seem to get a board completed in the RatOS configurator. I have tried three different boards tilt even after Z_TILT_ADJUST and a very fine bed meshI can't wrap my head around this, it all worked fine before. Not sure what happened to it overnight.VC3-300I tried to adjust the belt tension for the last hours, but somehow I can't get behind whats causing how to slow down probing routine/movementi like the custom prime blob a lot, as well as adaptive meshing, but the movement in between probing