RRC[

Rat Rig Community [Unofficial]•2y ago

mavi - ilezirabbit

Stringing Isue

Hello. I use "clone (Non original)mosquito magnum hotend" on my v core 3.1 printer. I use cura as a slicer. When I set the retraction setting to 5mm, there is no threading or speciation, but since I use a direct-drive extruder, the filament bubbles and constantly clogs at the 5mm retraction setting. That's why I reduced the retraction distance to 2mm, but as you can see in the picture, it leaves too much thread. When you make it 2mm less, it becomes more. I use esun pla+. The printer operates at 205 degrees. My preasure_advance setting is 0.04. No matter what I did, I couldn't fix this threading. Do you think my problem will be solved if I replace the hotend part with dragonfly BMO? Also, the filament is very dry and I just bought it today.