wanna use the flash bootloader of ST to flash my softwares using CAN-FD
Hello everyone,
I'm using STM32H745 for a small project using the both cores M4 and M7.
My question is : I want use the flash bootloader of ST to flash my softwares using CAN-FD, I can enter in boot mode (BOOT0 = HIGH) but I get no response from the board.
Is there anyone here has experienced such situation please ?
Thank you.
I'm using STM32H745 for a small project using the both cores M4 and M7.
My question is : I want use the flash bootloader of ST to flash my softwares using CAN-FD, I can enter in boot mode (BOOT0 = HIGH) but I get no response from the board.
Is there anyone here has experienced such situation please ?
Thank you.
Solution
This ST-Link V3 doesn't support CAN bootloader flashing. You'll likely need a host software with a CAN-FD interface to communicate with the bootloader. @wafa_ath
