RRC[

Rat Rig Community [Unofficial]•2y ago

Vitamin G

Struggling with PETG

I am running into a lot of issues with this print and I'm not sure how to fix it. I've run through all the filament tuning steps in orca including temp, flow rate, pa, and retraction. I am able to print a great benchy but when I try to print something for a project I'm working on it always comes out like crap. I have printed this model in ASA with no issues. The bottom layers are great and the first few infill layers are good and then it rapidly starts getting worse as the infill continues. The top layers are also good but then it starts having issues again with the perimeters. In the pictures below teal is the petg filament and the black is ASA as a comparison.