![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
PETG printing
ExtrusionHello, I got a new filament from devil design and got this issue. Previously with other filament speed tweaking and calibration helped, but I’m out of ideas here.
Printing with default petg settings from ratrig, just decreased volumetric speed to 20.
I did full beacon calibration, PA tuning and extrusion multiplier.
I keep getting this first layer issue on different temps, nothing helps.
Sometimes I also have an issue when extruder tries to push filament but gets stuck, and 1st layer becomes super thin. But babystepping Z offset helps with this.
Printing with default petg settings from ratrig, just decreased volumetric speed to 20.
I did full beacon calibration, PA tuning and extrusion multiplier.
I keep getting this first layer issue on different temps, nothing helps.
Sometimes I also have an issue when extruder tries to push filament but gets stuck, and 1st layer becomes super thin. But babystepping Z offset helps with this.
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}