![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
VCore4 printing Overture Nylon Z-Offset too high.
As I understand the Z-Offset is measured every time I print (by beacon). I had problem that print using Overture Nylon always got off the bed. I then found the Z-Offset was set to 0.069 instead of 0.059. After changing the Z-Offset to 0.059 everything is fine and the print does not lift from the bed.
I'm just guessing here, but maybe the temperature is not high enough to do a proper wipe of the nozzle on the bed.
Nevertheless, does anyone have an idea what to do to fix this on each print without manually changing the z-Offset after the print has started??
Is there a way to increase the wipe temperature for a specific filament (maybe additional gcode)?
Or is there a way to prevent automatic Z-Offset measurement when using a specific filament?
Any ideas or suggestions?
I'm just guessing here, but maybe the temperature is not high enough to do a proper wipe of the nozzle on the bed.
Nevertheless, does anyone have an idea what to do to fix this on each print without manually changing the z-Offset after the print has started??
Is there a way to increase the wipe temperature for a specific filament (maybe additional gcode)?
Or is there a way to prevent automatic Z-Offset measurement when using a specific filament?
Any ideas or suggestions?
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}