TMC ‘extruder’ reports GSAT

Hello, My printer keeps throwing this error at 95% or so of a 24 hour long print. I attached a picture below to show. Any idea what’s causing this? I checked my wiring and it’s all fine looking. Also, the print started looking bad before this error. And ideas?
No description
No description
Solution:
Yep. Was a bad connector. Put a new one on and good as new. Had the issue also where pin wasn’t fully in the socket. Using some silicone glue to hold it in made a big difference. I have thousands of hours no without issue
Jump to solution
6 Replies
cm
cmOP14mo ago
Anybody?
Helge Keck
Helge Keck14mo ago
this looks like a bad crimp this is a connection or shorting issue
cm
cmOP14mo ago
ok thanks
trivial78
trivial782mo ago
@cm where you ever able to fidgure out this issue?
Solution
cm
cm2mo ago
Yep. Was a bad connector. Put a new one on and good as new. Had the issue also where pin wasn’t fully in the socket. Using some silicone glue to hold it in made a big difference. I have thousands of hours no without issue
trivial78
trivial782mo ago
If you dont mind me asking what connector? And just like hot glue?

Did you find this page helpful?