New Y endstop position

Hi, I'm running through the new IDEX commissioning guide, I've completed the new X & DC endstop positions but when doing the new Y endstop position into the calculator it's complaining that the inserted values are invalid.
Please see the attached photos.
Current Y endstop -14.35, toolhead Y position above bed edge -14.00
Any guidance would be appreciated.

blacksmithforlife•11/14/24, 6:10 PM

because the endstop is at Y max not Y min. So take your bed depth and subtract that 14.35 from it

michaelaswoodOP•11/14/24, 6:16 PM

My bed is a 300. So 300 - 14.35 (285.75)?

Bblacksmithforlife because the endstop is at Y max not Y min. So take your bed depth and subtract t...

miklschmidt•11/14/24, 7:16 PM

It's at y-min on the VC4.

Mmichaelaswood My bed is a 300. So 300 - 14.35 (285.75)?

miklschmidt•11/14/24, 7:18 PM

Unfortunately @Cruz is at formnext right now, so he can't fix the guide, i'm not sure what that position should be in practice, i only know that y0 should be 5mm into your flex plate.

Mmiklschmidt Unfortunately @Cruz is at formnext right now, so he can't fix the guide, i'm no...

michaelaswoodOP•11/14/24, 7:20 PM

No worries... I don't think the -14.35 is far off.... The original position endstop is -14. But I guess there is an issue with the guide then?

Mmichaelaswood No worries... I don't think the -14.35 is far off.... The original position ends...

miklschmidt•11/14/24, 7:25 PM

not sure, could be!

New Y endstop position

Similar Threads

Similar Threads

Similar Threads