![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
RatOS installation: Flashing Octopus V1.1 via DFU - DFU not detected
Octopus v1.1 - RatOS-2.1.0-RC2. Initial setup, connecting RPi to Octopus, power supply is connected but not powered.
My board doesn't reflect the image in the setup Wizard, but I believe I've got the DFU jumper set correctly (img 1 & 2).
Moonraker lights up green, while Klipper turns red in the Wizard.
When I connect a monitor to the Pi I see an error message "unknown config object 'bed_mesh'" (img 3).
Can I continue with the build guide pt 12 electronics as my board is detected in the configurator or is there something wrong ?
My board doesn't reflect the image in the setup Wizard, but I believe I've got the DFU jumper set correctly (img 1 & 2).
Moonraker lights up green, while Klipper turns red in the Wizard.
When I connect a monitor to the Pi I see an error message "unknown config object 'bed_mesh'" (img 3).
Can I continue with the build guide pt 12 electronics as my board is detected in the configurator or is there something wrong ?
Solution
That's the dfu jumper. The one you've highlighted is the V_USB jumper that connects USB 5V to the onboard 5V rail (you very much want to remove that..).
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}