![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Z-Tilt Issue
Hello everyone!
I'm running Z-Tilt adjustment on my 3D printer, I have two steppers in the front and 1 in the back. (CoreXY for XY).
After Z-Tilt is done, if I start a print that goes form the from to the back, the rear half will be too far from the bed and the front half too close, I always end up "manually" moving the rear stepper up 1 step, and the front 2 steppers down one step each.
Basically; Z-Tilt gets kind of close, but consistently exactly the same "offset/error".
Probing points and stepper location points are spot on and rety tolerance is really fine, (0.01)
Any ideas?
I'm running Z-Tilt adjustment on my 3D printer, I have two steppers in the front and 1 in the back. (CoreXY for XY).
After Z-Tilt is done, if I start a print that goes form the from to the back, the rear half will be too far from the bed and the front half too close, I always end up "manually" moving the rear stepper up 1 step, and the front 2 steppers down one step each.
Basically; Z-Tilt gets kind of close, but consistently exactly the same "offset/error".
Probing points and stepper location points are spot on and rety tolerance is really fine, (0.01)
Any ideas?
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}