![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
vcore 3.1 z-tilt issue
Just setup vcore 3.1 using guide. Following the guide I setup my X,Y and all the steppers. The XY was inverted in the original guide and change them around and put ! On both directions pin now they home ok. But, Z tilt is a mess. The printer cant adjust z tilt and the probe points seems very wired too help please
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}