Endstop dual_carriage still triggered after retract

My V Core 4 400 IDEX was printing yesterday but today I get the error "Endstop dual_carriage still triggered after retract"
The machine is a pre-configured V Core 4 IDEX with BigTreeTech EBB42 V1.2 tool boards on T0 and T1.

Trouble shooting steps taken:
1. Endstop checked for continuity, pass
2. Endstop on T1 swithed with T0, x triggers properly but dual_carriage remained triggered.
3. Wire harness from the endstop to the toolboard checked for continuity, pass
4. Install a new EBB42 V1.2 toolboard on T1 and configuar, no change. Dual_carriage still triggered
5. Able to reflash the T1 toolboard, therefore the USB communication seems fine
6. Searched Discord and Answeroverflow, did not find anything helpful

The image blow shows the toolhead configs for both T0 and T1. On T1 the X endstop shows "false". Is this correct?

Any help/guidance will be much appreciated. Right now this printers is nothing more than a boat anchor.