![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
"Endstop y still triggered after retract" when running "BEACON_INITIAL_CALIBRATION"
Hi,
Model: VCore4 400mm IDEX
Following through calibration, only lower belts installed at this stage as per instructions.
Just done a clean install on VCore 4 400mm as I had this issue so tried a clean run first. Everything updated.
Run through the guide, checked endstops manually for each and all works as expected. When BEACON_INITIAL_CALIBRATION runs, the extruders both move to the far edges of X, then move forward towards the front of the machine and hit the Y endstop, the extruders then move toward centre slightly then I get the error "Endstop y still triggered after retract" 5 times in the console output.
Any help would be great, thank you.
Model: VCore4 400mm IDEX
Following through calibration, only lower belts installed at this stage as per instructions.
Just done a clean install on VCore 4 400mm as I had this issue so tried a clean run first. Everything updated.
Run through the guide, checked endstops manually for each and all works as expected. When BEACON_INITIAL_CALIBRATION runs, the extruders both move to the far edges of X, then move forward towards the front of the machine and hit the Y endstop, the extruders then move toward centre slightly then I get the error "Endstop y still triggered after retract" 5 times in the console output.
Any help would be great, thank you.
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}