RRC[

Rat Rig Community [Unofficial]•11mo ago

AOne

MCU connection lost.

Hello people. I'm close to despair with my fully assembled VCore 4 IDEX 400, which haven't made a single print yet.
When the printer is idling, at some point a message pops, that MCU hast lost connection. At first (when I started with commissioning 5 days ago), it was showing as a culprit T0, T1, Beacon, randomly. The last two days I disconnected and checked all the wiring, and put in order all the cables in the electronic's compartment. Bought 2 new USB cables and replaced the one from the kit. Now the error popping up is mentioning only the Beacon. Strangely, right after the rewiring a new issue started to appear and maybe both are related. When I power the printer, I manage to go through a Heightnap calibration ones and on any attempt afterwards, a red error says the meshing failed. Until the next restart. I've wiggled all the cables and connectors both toward the toolheads and inside the black box, but no error appeared. Did that 3 times to be sure. All the connectors look fine.
No idea what to try next. And I'm still waiting to receive new VAOC camera (under warranty) as mine appears to be faulty. Quite a lot of disappointment and frustration at this point. The Voron was more complicated on assembling, but I'm having harder time starting printing with the RatRig....
Any hints, ideas or tips are greatly appreciated or this big junk of metal and plastic will be searching for a new owner...