Rat Rig Community [Unofficial]RRC[
Rat Rig Community [Unofficial]â€ĸ12mo agoâ€ĸ
5 replies
Ferfi

PT1000 & Octopus PRO

Hi there,
I'm in the process of configuring Rapido ACE with PT1000 onto Octopus PRO.
I have dipswitches configured since that's the only thing that anybody is talking about when PT1000 is configured 🙂

I have a few questions and did not find answers on Octopus GIT, here or searching the web.
1. Where do I stick the wires for two-wire PT1000? I assume it has to be into the J47 connector but I don't know which 2/4 pins... (pics)
2. What's a correct config? Do I just chuck FORCE_P as a pin name? 
sensor_type: PT1000
sensor_pin: FORCE_P
pullup_resistor: 4700


Answers are appreciated !
image.png
image.png
Was this page helpful?