Turbulence after corners
Hi team,
Have an issue where there’s shadows or turbulence after the printer turns a corner. Is this a IS or too high accel issue? Are their tests I can run to try and nail down the issue?
VCore4 500
PETG or PLA
4 Replies
What's your PA value? Might need to tune PA again
Also looks like underextrusion as the top surface doesnt look great
its been a few months since i set it up, you're probably right
its a pretty solid infill when the angle isnt like this, and this is only half way through the print and paused. thanks for the tip ill play with it. I think its running 99% extrusion atm as the first layer was terrible and dropping blobs everywhere when on 100%
oh if its only halfway through the print that would explain the top surface
maybe worth to try and dry the filament, you have quite a bit of stringing and some blobs here and there, unlikely to be the cause of the turbulence however
PA best guess