Front right corners lift

When printing larger objects on my vcore 3.1 300, the front corner of them has started to lift very consistently. I've cleaned with dish soap and warm water with no improvement. It's always this corner, if I move things to the back left it'll go away. Could the people which shows no signs of degradation visually somehow be losing adhesive properties?

TheTikOP•7/20/25, 2:16 PM

TheTikOP•7/20/25, 2:17 PM

I didn't want to, but I may try glue stick next just in that area

TheTikOP•7/20/25, 2:18 PM

Actually, looking again this might be a first layer issue

Tomskis•8/6/25, 7:44 AM

Did you find the solution??

TheTikOP•8/6/25, 4:01 PM

Not yet, been dealing with a cold-end clog then had to leave to work GenCon. I DID run a new mesh and it was quite different, so that might have done it, just need to clear the clog soni can get more than half a first layer down

Front right corners lift

Similar Threads

Similar Threads

Similar Threads