Major issue with print now printer homes incorrectly in the y axis
So I had a print fail a few hours in and the blod it created required me to basically reprint everything on the print head.
So I rebuilt the print head, but now the y axis home in the wrong directions. Manal moves are in the correct direction I have not moved any steeper cables or anything. If I flip the y direction with then it "binds" when tying to move in the y direction. Any thoughts?
Is it possble the drivers got hurt?
3 Replies
If you think it’s a motor driver swap drivers with another one on your board and test again.
i had this issue on a new build - turns out i had inadvertently swapped left & right motor connections
I saw that answer before but I didn’t unsure anything from the board, nor steppers but worth a shot. Ty